Specific Commands
For precise control of your desk, use specific commands that allow you to adjust to exact heights or determined increments.
By Exact Height
Section titled “By Exact Height”Metric System
Section titled “Metric System”Use measurements in centimeters or meters for greater precision:
- “Set it to 110 centimeters”
- “Adjust to 1.1 meters”
- “Move it to 115 cm”
- “Configure height 85 centimeters”
- “Set to 1 meter 20”
Imperial System
Section titled “Imperial System”For users who prefer feet and inches:
- “Adjust to 47 inches”
- “Set it to 4 feet”
- “Raise it to 3 feet 11 inches”
- “Configure 42 inches”
- “Set to 3 feet 6 inches”
By Increments
Section titled “By Increments”Increments in Centimeters
Section titled “Increments in Centimeters”- “Raise 10 centimeters”
- “Lower 5 cm”
- “Elevate 2.5 centimeters more”
- “Descend 7 cm”
Increments in Inches
Section titled “Increments in Inches”- “Raise 2 inches more”
- “Lower 1.5 inches”
- “Up half an inch”
- “Down a quarter inch”
Descriptive Increments
Section titled “Descriptive Increments”- “Down a little” → Lowers approximately 2-3 cm
- “Up a bit more” → Raises approximately 1-2 cm
- “A tad higher” → Minimal increment upward
- “A touch lower” → Minimal increment downward
Tips for Specific Commands
Section titled “Tips for Specific Commands”Maximum Precision
Section titled “Maximum Precision”- Use exact numbers for work requiring specific heights
- Combine measurements: “1 meter 15 centimeters”
- Specify the unit clearly
Fine Adjustments
Section titled “Fine Adjustments”- Small increments are perfect for ergonomics
- Use “a little” for 2-3 cm adjustments
- “A bit” for 1-2 cm adjustments
Compatibility
Section titled “Compatibility”- The system recognizes both measurement units
- You can mix specific commands with direct ones
- Precision is ±0.5 cm
Specific commands give you complete control over your desk height.